Kyocera DuraForce XD(E6790) Boot Loop

Hello all,

The phone was previously rooted, I just wanted to retry to get rid of the optimizing app problem. With that said, the phone is rooted, and I previously had USB debugging enabled. I reset to factory using the Android Recovery, so does this mean USB debugging was not enabled after resetting?
These were my steps:
Install and run KingRoot
Purchase Super-Sume Pro ($4) to replace KingRoot with SuperSu
On reboot it got stuck in boot loop. I have tried Android System Recovery (lmy47v) but my options are only

Code:
>reboot system now >wipe data/factory reset >wipe cache partition >reboot to bootloader >power down >view recovery logs

I have tried all of these options several times.
I have installed ADB on windows as well as the Kyocera drivers here: kyoceramobile.com/support/drivers
I have not been successful in getting access to the phone with ADB.
I have tried to get the phone into fastboot mode by combinations of key presses, but I have not been successful. Does this phone have fastboot? Here are the recovery logs: imgur.com/a/Sn9zD

What is left? I really like this phone and use it as a waterproof GPS and would have to have made a paperweight out of it. Please help!

Show Accepted Answer

Guest Quick Reply (No URL, BBcode or HTML)

Last post by abraham03
1 hour ago
Last post by sandra.mcclure
3 hours ago
Last post by uriel.tromp
22 minutes ago
Last post by eudora87
37 minutes ago
Last post by theodore.schaefer
4 hours ago
Last post by barton.trinity
3 hours ago
Last post by gdeckow
46 minutes ago
Last post by vleuschke
4 hours ago